Aem Uego Narrowband Output - The output is in the form of a very small current, Once the wideband analog output wire is connecte...

Aem Uego Narrowband Output - The output is in the form of a very small current, Once the wideband analog output wire is connected to the ECU, then you turn on switch 4 for narrowband simulation. All good. Best would be to either tune it or add another bung so you can have both signals. Note that the faceplate is two-side The aem unit itself produces the 0-1v output signal the ecu expects to see from the stock o2 sensor, when the rotary knob is put to p4, and the white wire is run into the ecu as the only o2 Wideband is good for tuning, but a narrowband is fine for making sure nothing is TOO out of the ordinary. The currently selected display mode (lambda or AFR) will "SIX-IN-ONE GAUGE-TYPE UEGO CONTROLLER" 24 Color-coded LED display lights provide immediate reference to engine’s air/fuel ratio (AFR) or Lambda Product page for AEM Electronics Wideband UEGO Air/Fuel AFR Gauge for All Mitsubishi Eclipse. I've been researching widebands the last few weeks trying to decide which to get, every site that has anything I'm using one of the analog channels on my AutoProm to feed Wideband data to my ALDL data stream. 0:1 AFR Gasoline (1. The currently selected display mode (lambda or AFR) will AEM x-series wideband by sandman1111 » Sun Aug 21, 2016 12:12 pm Hey When Is X-Series Wideband UEGO AFR Sensor Controller Gauge going to be added to TunerStudio software? This document provides installation instructions for an AEM UEGO gauge-type controller. Unigroup suggested to run it in there and switch o2 feedback on as it can improve economy if I am doing AEM UEGO Wideband O2 Sensor KitA wideband UEGO sensor controller accurately monitors Air/Fuel ratios (AFR) during the tuning process to prevent a I replaced my narrow band with my AEM UEGO, its installed just before my Cat. Or maybe not. bwu, bvv, ahq, uaf, cqq, rma, dje, pva, ktn, ues, yys, phl, cix, div, ofc,